Miller Edge Field Edge Form

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

MillerEdge Sensing Edge Field Worksheet

Select & Configure a Sensing Edge for Doors

Customer:

Job #:

Operator Brand:

Door Model:

1. Sensing Edge Model

A. For SECTIONAL Doors (Select based on Door Thickness)

B. For ROLLING STEEL Doors (Select based on Bottom Bar)

MT22 (Double Angle Bottom Bar)
ME113 or ME123 (Solid Piece)
MC22 (Cornell Door with T)
MT22 (Cornell Double Angle)

Custom Model (if applicable):

2. Color

If ME110, ME112, ME113, ME123:

Black Yellow (ME123 Only) Gray

If MT22, MC22, MUxx:

Black Yellow Y/B Stripe XR5 (Yellow)

3. Outlet Location

Face the side of the door the operator is mounted to. Is the operator on the left or right?

Right (RH) Left (LH) Universal / End

4. Active Length

Sectional: Measure width of sectional panel. Rolling Steel: Guide to guide minus 2 inches.

Feet

Inches (1/4" increments)

5. Monitoring

Monitored (If monitored photo optics are NOT installed and operator > Aug 2010)

Non-Monitored (If photo optics installed OR operator

6. Switch Configuration

If Monitored:

2-wire Monitored (Standard)
4-wire Monitored (LiftMaster w/ CPS-EI)

If Non-Monitored:

2-wire Non-Monitored
Air-Wave
Pneumatic

7. Monitoring Method (For 2-Wire Monitored Only)

Select method based on Operator Brand.

Type	Termination	Brands
T1 (Green)	8.2K Resistor	European Brands, MEL-II-K10 (Wireless)
T2 (Blue)	10K Resistor	Cookson, Cornell, Lawrence, Linear, LiftMaster, Manaras, Raynor, SM-102 (Wired)
T3 (Red)	Diode Capacitor	Overhead Door / Genie, MEL-II-OHD (Wireless), SM-101 (Wired)

MillerEdge Technical Support: 800-220-3343 | info@milleredge.com

MillerEdge Sensing Edge Field Worksheet