The Genie 37714S.S / 37714R.S Wire Clip is an OEM replacement part designed to secure low-voltage accessory wiring—such as Safe-T-Beam sensor leads and wall console/control wires—along the opener rail on select Genie garage door openers. By keeping conductors neatly retained and away from moving parts, this clip helps maintain reliable sensor operation and a clean, professional wire route on residential Genie chain, belt, and screw drive systems. It is a direct-fit wire management solution commonly referenced in Genie parts diagrams for models that route accessory wiring along the rail.
Installation is straightforward: the clip snaps into the rail’s pre-formed holes and holds the low-voltage wires in place as they run from the opener head to the safety sensors or wall control, depending on the model layout. For best results, follow your opener’s manual or parts breakdown to confirm compatibility with your specific unit and to see factory-recommended wire routing. Disconnect power before servicing, avoid pinching or crushing the conductors, and keep low-voltage wiring separate from line-voltage cabling. Use 37714S.S when a single replacement is needed or 37714R.S when the alternate packaged variant is specified by the parts list. This genuine Genie wire clip is a simple, effective way to restore OEM wire retention and ensure dependable Safe-T-Beam and wall control performance.