The Marantec 97304 Micro Remote Clip and Programming Connector is an original accessory and replacement kit for Marantec micro/keychain garage door opener remotes. It combines a snap-on mounting clip for everyday carry or visor-style mounting with Marantec’s programming connector (also called a programming jumper) used to add or replace a handheld remote without accessing the opener each time. The connector bridges the two-pin programming ports found on compatible Marantec micro remotes, allowing you to transfer the remote’s radio code from an existing, working handset to a new one for quick setup. This accessory is commonly used with Marantec micro remotes in North America that utilize the Marantec M3 platform (315 MHz) and are paired to Marantec residential or light commercial openers that support the two-pin programming method.
To use, snap the new clip onto your micro remote as needed, then plug the programming connector into the two compatible remotes’ programming ports as directed in the Marantec instructions; follow the LED prompts to clone the code from the working remote to the new remote, then complete any required receiver “learn” step at the opener head if specified by your model. No special tools are required. For safety, program with the door area clear and test operation from a safe position. This is not a universal accessory; it is intended only for Marantec micro/keychain remotes that have the two-pin port and for Marantec openers designed for this programming process. Always confirm your opener and remote model for compatibility and follow the manufacturer’s programming procedures.