LiftMaster 041D7742-5 Travel Module, 3/4 HP

In stock
SKU
041D7742-5

Quick Overview

  • OEM replacement for LiftMaster 041D7742-5 Travel Module, 3/4 HP; restores accurate door travel and limit control
  • Compatibility: Fits select LiftMaster 3/4 HP chain- and belt-drive openers that specify part 041D7742-5; verify via your opener’s parts list or the label on the existing module
  • Direct-fit design matching original mounting footprint and connectors for a quick swap with no wire splicing
  • What’s included: 1 LiftMaster 041D7742-5 travel module assembly (module only)
  • Installation: Plug-in replacement—disconnect power, remove old module, install new unit, then reprogram up/down travel per the owner’s manual
  • Performance: Helps correct drifting limits, short travel, overrun, or failure to set limits after power interruptions
  • Safety: Maintains safety reversal and photo-eye operation when travel and force are properly adjusted after installation
$35.35

Secured and trusted checkout with

The LiftMaster 041D7742-5 Travel Module is a genuine OEM replacement control module engineered for select LiftMaster garage door openers rated 3/4 HP. This internal travel control component manages the opener’s up and down travel limits, helping the door start, stop, and reverse correctly within the programmed range. If your opener will not set limits, over-travels, or behaves inconsistently during opening or closing, replacing a failed travel module with the 041D7742-5 can restore proper operation. Designed for residential garage door systems, it integrates with the opener’s logic board to coordinate travel calibration and safety reversal behavior when used with properly functioning photo-eyes and force settings.

This is not a universal part; compatibility is limited to specific LiftMaster operators that use the 041D7742-5 module. Always verify the exact part number on your existing module or in the opener’s parts list before ordering. Installation is performed inside the opener head by disconnecting power, removing the cover, swapping the module harness/connector, and reassembling. After installation, the door travel limits must be reprogrammed per LiftMaster instructions, and the safety reversal must be tested in accordance with UL 325 guidelines. For best results and to ensure safe operation, confirm door balance and perform full limit and force adjustments after replacement. Keywords: LiftMaster 041D7742-5 travel module, 3/4 HP garage door opener replacement part, OEM limit control module, residential opener compatibility.

0
Rating:
% of 100
Write Your Own Review
You're reviewing:LiftMaster 041D7742-5 Travel Module, 3/4 HP
Your Rating
Customer Questions
How do I install a 41D7742-7 or 41D7742-5 Travel module
Tools Required 1/4" nut driver or socket Phillips head screwdriver Flat head screwdriver Preparation Note: Close the garage door before installing the travel module. Disconnect all electric and battery power...
Did you find what you were looking for?