The LiftMaster OES-COND Optical Edge Conduit Install Kit is an accessory for installing a LiftMaster Optical Edge System (OES) using hard conduit on commercial overhead doors. It provides a protected, hardwired pathway for the OES safety-edge wiring between the moving door and the operator, helping safeguard the connection in demanding environments where a coil cord isn’t preferred. Use it as a replacement part or an upgrade when transitioning to a conduit-based run on sectional or rolling steel doors in warehouses, loading docks, and other commercial or industrial applications.
OES-COND is intended for use with LiftMaster Optical Edge System components and LiftMaster commercial door operators that accept a monitored optical edge input. Installation typically involves routing conduit along the jamb to the bottom bar, pulling the OES lead through the conduit, terminating conductors at the operator control board per the LiftMaster wiring diagram, and configuring the operator for Optical Edge monitoring before performing required safety tests. For compliance and reliability, have a qualified door professional complete the wiring, sealing, strain relief, and commissioning steps, and verify proper operation of the safety edge and door controls after setup.