The Clopay EZ-Set 6' Torsion Tube, galvanized and 16 gauge, is the primary shaft used in Clopay’s homeowner-friendly EZ-Set torsion spring system for sectional garage doors. Installed across the header, it supports the EZ-Set torsion spring(s) and cable drums and transfers torque evenly to lift and lower the door. The galvanized finish helps resist corrosion in humid garages, while 16-gauge wall thickness provides rigidity to minimize shaft deflection under load for smoother, quieter operation on residential doors.
Designed specifically for Clopay EZ-Set hardware, this replacement torsion tube works with the EZ-Set winder, cones, drums, center support, and end bearing plates engineered for the system. Typical installation involves seating the tube in end bearings, securing drums and spring components per Clopay instructions, and winding with the EZ-Set winder using a ratchet or power drill as directed. Only qualified installers or experienced DIYers following Clopay’s safety procedures should service torsion systems; always remove spring tension before disassembly, lock the door in the down position, and verify balance after winding. Use on residential sectional doors that are configured for EZ-Set torsion; not intended for standard commercial torsion hardware unless explicitly specified by the manufacturer.