The Clopay EZ-Set Torsion Tube Coupler is a connector for Clopay residential garage doors equipped with the EZ-Set torsion spring system. It joins two EZ-Set torsion tubes to create a continuous shaft across the door opening, transferring torque from the EZ-Set spring assembly to the cable drums while keeping the shaft straight and true. This helps maintain smooth lifting, proper door balance, and dependable operation. Commonly used at the center of wider openings where two tube sections meet, the coupler serves as a direct replacement part when repairing or rebuilding an EZ-Set torsion setup and is intended specifically for Clopay EZ-Set components rather than standard torsion hardware.
Installation should follow Clopay’s EZ-Set instructions and be performed only when all spring tension has been fully released, with the door secured to prevent movement. Work on torsion systems can be hazardous; consult the official Clopay manual for your door model or hire a qualified technician. This coupler supports typical EZ-Set use cases such as residential single- and double-car garage doors and is often referenced as a torsion tube coupler, shaft coupler, or center coupler for the Clopay EZ-Set torsion spring system.